Aspire - Pixo - Pod - 0.4 Ohm - 2 pcs

The Aspire Pixo Pod is the refillable pod with a built-in mesh coil for Aspire Pixo pod systems. According to retailer information, the tank holds 3 ml. It is available with 0.4, 0.6, 1.0 and 1.2 ohm, each in a pack of two.

Resistances and power

• 0.4 ohm: 23 to 30 watts, DL (Direct Lung)
• 0.6 ohm: 14 to 19 watts, RDL (Restrictive Direct Lung), also listed for MTL by retailers
• 1.0 ohm: 10 to 15 watts, MTL (Mouth to Lung)
• 1.2 ohm: 9 to 13 watts, MTL

The tank is filled from the side (side fill), with a silicone plug sealing the opening. The pod is made of PCTG.

Compatible devices

According to retailer information, the pod fits the Aspire Pixo, Pixo Aura, Pixo Neo and Pixo Max. The coil is built in and is a consumable part. When performance drops, replace the whole pod.

How to fit the pod

1. Remove the pod from the mod.
2. Open the silicone cap on the side, add liquid and close the cap again.
3. Leave the pod for about 5 minutes to let the cotton in the coil soak.
4. Fit the pod and start at low power within the wattage range for your resistance.

You can find compatible mods from the range among the Aspire Pixo devices.

What's included

• 2 × Aspire Pixo Pod with built-in coil in the selected resistance
• Liquid is not included

Frequently asked questions

Which resistance suits which draw style?

1.0 and 1.2 ohm are designed for MTL, 0.6 ohm for RDL and 0.4 ohm for DL. The wattage range increases as resistance decreases.

Can I replace the coil?

No. The coil is inside the pod; you always replace the whole pod.

Why does the pod taste burnt immediately after filling?

Usually the cotton was not yet saturated. Leave the filled pod for a few minutes and start at low power.