Kaloud - Lotus - 1+ - Violis
Available soon - sign up to get notified
Heat regulation made easy
Adjust the heat easily by simply turning the lid. The long handle also ensures you don't burn your fingers.
Premium finish
The Kaloud Lotus I Smokebox has a super premium finish and thanks to the clever design on the bottom, you're now less likely to run out of coals.
Long lasting smoke
With the Kaloud attachment, the coals burn longer to ensure maximum flavor from any tobacco.
Comes with a certificate of authenticity
Each Kaloud Lotus comes with a certificate of authenticity. Kaloud Lotus I - one of the most beautiful HMDs on the market - makes heat control easier than ever!
Currently, there are probably few products that cause as much of a stir in the shisha market as the Kaloud Lotus HMDs. The reason for this is that the Kaloud Lotus not only looks great, but is also very high quality and has good smoking characteristics. Made in the USA, the Kaloud Lotus I represents ultimate craftsmanship and extremely easy heat control. The lid with AirFlow Control Technology provides extremely high temperatures when the vents are closed, but if you open the vents a quarter turn, the heat escapes upwards. Thanks to its larger volume, the redesigned Kaloud can now use three types of charcoal from the start. Plus, the bottom has nubs to ensure the coals never run out again. One of the best things about the Kaloud Lotus I is how simple the head design is: no peeling, screwing, or foil pressing required - just insert three coals into the HMD, adjust the airflow control. And off you go. Now just sit back and enjoy. Pure smoking experience! The matching brush from our store makes your equipment really clean again.
Notice:
The charcoal reservoir of the Lotus I is relatively small, so it can not hold three 26 coals until it has been lit for a while. When the coals burn a little, three of them can be added to the smokehouse.
Compatible with all standard size Hookain bowls.
Kaloud
Kaloud is a shisha manufacturer from Los Angeles. At Hookain Onlineshop you will find the Kaloud Lotus 1+, an aluminium heat attachment, in the colours Azuris, Niris and Violis.
Lotus 1+: the Kaloud HMD
The Lotus 1+ is an HMD, short for heat management device: an attachment that sits on the bowl and holds the coals inside it. You control the heat by turning the lid. The long lever on the side makes sure you do not burn your fingers while doing so.
- Aluminium
material - 3 coals
room inside, standard size - approx. 7.5 cm
diameter - USA
origin
How to smoke with the Lotus 1+
- Bowl: Ideally a wide phunnel, a bowl with a raised centre hole. Pack it as a nub or full-contact setup, where the filling reaches the underside of the HMD and the nubs pass the heat on.
- Coals: Place two coals in the middle and the third between them and the edge.
- Warming up: Give the bowl two to three minutes to heat up.
- Adjusting: If it gets too hot after five to seven minutes, take out the edge coal or turn the lid further open.
Which bowl suits the Kaloud Lotus 1+?
A wide phunnel. In principle, all common bowls designed for an HMD will fit.
How many coals fit in the Lotus 1+?
Three standard-size pieces of coal.
How do I control the heat?
By turning the lid. If that is not enough, take out one coal.
What is the Lotus 1+ made of?
Aluminium.
Manufacturer
Kaloud Inc.
1442 East Lincoln Avenue, Suite 216
Orange, California 92865
USA
E-Mail: support@kaloud.com
Responsible Person
Reza Bavar
Founder & CEO, Kaloud Inc.
1442 East Lincoln Avenue, Suite 216
Orange, California 92865
USA
E-Mail: reza@kaloud.com
| Color: | Blue, Violet |
|---|---|
| HMD Compatibility: | Standard |
| Origin: | USA |
| Material: | Stainless Steel |
Login
25 May 2023 09:29
Meine Nummer 1
Schreckt erst ab da er nicht gerade der günstigste HMD ist, Preis Leistung stimmt aber zu 100% und wird daher fast jedesmal in meinem Setup benutzt. Der Deckel ist ein Gamechanger gegen Ende der meisten Sessions. Habe die Colorway Azuris.
