OXVA - Xlim Pro 2 - Kit - Silver Carbon

The OXVA Xlim Pro 2 from the Xlim series is a stick-format pod kit with a built-in 1300 mAh battery, 5 to 30 W output and top-fill pods with 2 ml capacity and a mesh coil. It measures 114.5 × 25 × 15 mm, weighs 67 g and has a 0.56-inch colour display. The body is made of zinc alloy with an IML or synthetic leather finish. The Silver Carbon version has a Silver body.

Battery and power

Charging is via USB-C at 5 V / 2 A; the battery is stated to reach 85 percent in about 25 minutes. Power ranges from 5 to 30 W, and resistance from 0.3 to 3.0 ohm. The device cuts off after 8 seconds of continuous drawing; it also has protection circuits against short circuits, overcharging, deep discharge and overheating.

Pod and coils

The Xlim Top-Fill Pods hold 2 ml and fill through a silicone plug at the mouthpiece while remaining on the device. The mesh coil is built into the pod; the entire pod is replaced. It is held in place magnetically. Compatible pods are Xlim Top-Fill Pods with 0.4, 0.6, 0.8 and 1.2 ohm, as well as Xlim V2 Side-Fill Pods with 0.6, 0.8 and 1.2 ohm. The kit includes a 0.6 ohm pod for RDL and a 0.8 ohm pod for MTL.

Operation

The device is draw-activated; all settings are made using multiple clicks of the power button on the side. The display shows battery level, power, resistance, puff duration and puff count; the colour animations are adjustable. The airflow slider on the side provides continuous airflow adjustment between MTL and RDL.

Getting started with the Xlim Pro 2

1. Charge the device via USB-C.
2. Fill the pod through the silicone plug at the mouthpiece and leave it for a few minutes to let the coil soak.
3. Start at low power within the wattage range specified in the instructions for your pod, and only increase it after a few draws.
4. Set the airflow slider to MTL or RDL.

What's included

• 1 × Xlim Pro 2 Pod-Mod (mod)
• 1 × Xlim Top-Fill Pod with 0.6 ohm (pre-installed)
• 1 × Xlim Top-Fill Pod with 0.8 ohm
• 1 × USB-C charging cable
• 1 × button operation guide card
• 1 × instruction manual

Frequently asked questions

Which pods fit the Xlim Pro 2?

Xlim Top-Fill Pods with 0.4, 0.6, 0.8 and 1.2 ohm, and Xlim V2 Side-Fill Pods with 0.6, 0.8 and 1.2 ohm.

Can I replace the coil separately?

No. The mesh coil is built into the pod; replace the entire pod.

Do I have to remove the pod to fill it?

No. Fill it through the silicone plug at the mouthpiece while it is on the device.

How do the two pods in the kit differ?

The 0.6 ohm pod is intended for RDL; the 0.8 ohm pod is for MTL. Both hold 2 ml.