Uwell - Caliburn G4 Mini - Kit - Schwarz

The Uwell Caliburn G4 Mini in Black works with draw activation: a draw on the mouthpiece activates the device. The built-in battery has 1,100 mAh. The power adapts to the inserted pod and is 35 watts at most.

Fill level and air supply

The transparent G4 pod shows how much e-liquid is in the tank. The airflow control, a side air regulator, changes the draw resistance. You check the fill level yourself and refill in good time.

0.6 ohm pod in the set

The supplied pod holds 3 ml and contains a built-in mesh coil with 0.6 ohm. The mesh heating element is designed for RDL, a direct-lung draw with restricted air supply.

What you get

Included are a Caliburn G4 Mini, a Caliburn G4 pod with 0.6 ohm and an instruction manual; e-liquid is not included. The device weighs 46 g, measures 112.7 × 24.1 × 14 mm and has a USB-C charging port. You can find matching e-liquid among our e-liquids.

Goes with

You can get replacement pods as the Caliburn G4 pod 0.9 ohm or the Caliburn G4 pod 0.4 ohm, each in a pack of three. You can find more devices from the brand under Uwell.

Frequently asked questions about the Uwell Caliburn G4 Mini

Which pods fit the Caliburn G4 Mini?

The Caliburn G4 pods with 0.4, 0.6 and 0.9 ohm as well as the Caliburn G3 pods with 0.4, 0.6, 0.9 and 1.2 ohm. The G3 pods with 0.6, 0.9 and 1.2 ohm have a tank volume of 2.5 ml.

How do I prepare a new pod?

Take the new pod out of the device and remove the insulating film on its underside. Open the side filling plug, fill in e-liquid and close the plug completely again. Insert the pod and wait ten minutes after the first filling before you draw on it. This lets the cotton soak with e-liquid.

How do I refill e-liquid later?

To refill an already prepared pod, open the side filling plug. Pour e-liquid in through the filling opening and then close it completely. The pod can stay in the device. Check the fill level and refill at the latest when it drops below the MIN mark.

Can I change the coil individually?

No. The coil is built in. When it is worn out, you replace the complete pod.

How do I charge the Caliburn G4 Mini?

Connect the device to a suitable USB power source with a USB-C cable. While charging, the LED flashes red, blue or green depending on the charge level. When charging is complete, it lights up green continuously.

What do the LED colours mean while vaping?

While drawing, green stands for more than 60 percent battery level, blue for 30 to 60 percent and red for less than 30 percent. Green while vaping therefore does not mean the battery is fully charged.