GeekVape - S30 - Cartridge Pod with Atomizer - Boost Version - 2 pcs. - 0.6 Ohm

The GeekVape S30 cartridge in the Boost version is a pod with a built-in coil for the pod mods GeekVape S30 and S30 Pro. It holds 4 ml, is filled from the side and has an airflow control. It is offered in a pack of 2 with 0.4 ohm, 0.6 ohm or 1.0 ohm. This listing is the pack with 0.6 ohm.

Resistances and power

• 0.4 ohm: 30 to 35 W
• 0.6 ohm: 15 to 30 W, RDL
• 1.0 ohm: 5 to 15 W, MTL

The coil is built in. When it is used up, you replace the whole cartridge.

Matching devices

The pods with 0.6 ohm and 1.0 ohm fit the GeekVape S30 and the S30 Pro. The 0.4 ohm pod is intended exclusively for the S30 Pro and does not run on the S30. You can find the devices themselves among the GeekVape mod kits, and replacement pods for other devices under pods with built-in coils.

How to insert the cartridge

1. Fill the cartridge with e-liquid from the side, up to 4 ml at most, and close the opening.
2. Let it stand for a few minutes so that the coil soaks.
3. Plug the cartridge into the device.
4. Start with low power in the range of your resistance and set the air flow at the airflow control.

Scope of delivery

• 2 × S30 cartridge Boost version with built-in coil in the chosen resistance
• 1 × instruction manual

Frequently asked questions

Does the 0.4 ohm cartridge also fit the S30?

No, it is intended only for the S30 Pro.

Can I replace the coil individually?

No, the coil sits fixed in the cartridge.

How much e-liquid fits in the cartridge?

4 ml. The filling opening is on the side of the cartridge.