Vaporesso - GTI - Vaporizer head Mesh Coil - 5 pcs - 0.4 Ohm

Vaporesso GTI Mesh Coils are replacement coils for iTank range tanks and the GEN 80S. They come with 0.15, 0.2 and 0.4 ohm, all for direct lung (DL) draws. A pack contains 5 coils.

Resistances and power

• 0.15 ohm: 75 to 90 watts, ideally around 85 watts
• 0.2 ohm: 60 to 75 watts, ideally around 65 watts
• 0.4 ohm: 50 to 60 watts, ideally around 55 watts

The lower the resistance, the more power and continuous load the coil demands from the mod. For resistances below 1.0 ohm, you need a mod that can supply this continuous load.

Compatible devices

The coils fit the Vaporesso iTank, iTank 2 and iTank T tanks, as well as the Vaporesso GEN 80S set.

How to replace the coil

1. Switch off the device and empty the tank.
2. Remove the old coil and insert the new coil until it fits securely.
3. Saturate the cotton with liquid, fill the tank and leave the coil to soak for about 5 minutes.
4. Start at the lower end of the wattage range and adjust the power gradually.

What's included

• 5 × Vaporesso GTI Mesh Coil in the selected resistance

Frequently asked questions

Which resistance do I need?

That depends on the power your mod can reliably deliver. 0.4 ohm runs at 50 to 60 watts, while 0.15 ohm starts at 75 watts.

When should I replace the coil?

Coils are consumable parts. If the draw weakens or the vapour tastes burnt, it is time for a new coil.