Vaporesso - Eco - Nano - 2 - Gray

The Vaporesso ECO Nano 2 is a compact pod system with a built-in 1000-mAh battery and refillable pod. The pod holds 6 ml, is filled from the bottom and comes with a 0.6-ohm mesh coil. No fire button is needed; the device uses draw activation. This version comes in grey.

Battery and power

The 1000 mAh battery is built in and charges through the USB-C port at 5 V and 1 A. Output power is a maximum of 16 watts and adjusts automatically to the inserted pod; there are no settings. The housing is made of aluminium alloy and measures 77 × 44.7 × 18 mm; the pod is made of PCTG.

Pod and coils

The coil is fixed inside the pod and cannot be replaced separately. When it is worn out, replace the whole pod. The included pod has 0.6 ohm, suitable for MTL and RDL. Pods with 0.8 ohm and 1.2 ohm for MTL draws are available separately, all from the ECO Nano range. The pod attaches magnetically to the mod. Fill from the bottom: open the silicone plug, add liquid and close the plug again.

Operation

There are no buttons. Draw on the mouthpiece and draw activation detects the draw and heats the coil. The device has no display. An LED on the side shows the charge level in four stages, each representing a quarter of the battery charge.

Getting started with the ECO Nano 2

1. Charge the battery via USB-C before first use. Cable and power adapter are not included.
2. Fill the pod from the bottom without overfilling.
3. Leave the pod for a few minutes to let the coil soak. Skipping this pause risks scorching (dry hits).
4. Fit the pod, start with short, gentle draws and only then take longer draws.

What's included

• 1 × Vaporesso ECO Nano 2 pod mod with built-in battery
• 1 × ECO Nano Pod with mesh coil, 0.6 ohm, 6 ml
• 1 × instruction manual

Frequently asked questions

Is a USB-C cable included?

No. You need a separate cable and power adapter. The device charges via USB-C at 5 V and 1 A.

Which pods fit?

ECO Nano range pods with 0.6, 0.8 or 1.2 ohm.

Can I change the coil separately?

No. The coil is built into the pod; you always replace the whole pod.

What should I do if it tastes burnt?

Usually the pod is almost empty or the coil is not saturated. Refill, wait a few minutes and restart. If the draw still tastes burnt, the coil is worn out and you replace the pod.