Elfbar - Elfx Mega - Empty Pod - 10ml - 0.6 Ohm

The Elfbar ELFX Mega empty pod is an empty replacement pod with a capacity of 10 ml for the Elfbar ELFX Mega kit. The dual mesh coil is built into the pod, and it is filled from the side through a filling port with a silicone cover. The pod is available with 0.6 ohm and with 0.8 ohm.

With 0.6 ohm this pod is the looser choice. It needs the device from the Elfbar ELFX Mega series.

Resistances and draw characteristics

Both variants work with a dual mesh coil in QUAQ technology. According to retailers, the 0.6 ohm pod is designed for loose MTL up to RDL, the 0.8 ohm pod for tight MTL. The ELFX Mega Kit has Eco and Turbo modes: in Eco mode the two mesh elements heat alternately, in Turbo mode at the same time.

Matching device

The pod only fits the Elfbar ELFX Mega kit. The coil cannot be replaced individually. If the power or draw characteristics weaken, you replace the whole pod.

How to use the pod

1. Open the silicone closure on the side filling port.
2. Fill e-liquid slowly, not above the MAX mark, and close the closure carefully.
3. Let the pod rest for a few minutes so the coil soaks up fully. Retailers state 5 to 15 minutes. Otherwise a dry hit is likely.
4. Insert the pod into the kit and start with short puffs.

Scope of delivery

• 1 × Elfbar ELFX Mega empty pod 10 ml in 0.6 or 0.8 ohm, empty and without e-liquid
• 1 × leaflet with usage information

Frequently asked questions

What distinguishes 0.6 and 0.8 ohm?

The 0.6 ohm pod draws looser, from open MTL to RDL, with more vapor production. The 0.8 ohm pod is intended for tight MTL.

Can I fill the pod several times?

Yes, it is supplied empty and can be filled several times. Since the coil is built in, you replace it completely as soon as it weakens.

Does the pod fit other ELFX devices?

No, retailers list it only for the ELFX Mega kit.