Geekvape - P Series - Head - 0.4 Ohm - 5 pcs

The Geekvape P Series Head with 0.4 ohm is an atomizer head for the direct-lung draw (DL). It works in the range of 50 to 60 watts and belongs to Geekvape devices of the Aegis Boost Pro family. One pack contains 5 heads.

Resistance and power

With 0.4 ohm the head is in the sub-ohm range. The recommended wattage range is 50 to 60 watts. Start at the lower end and go up in small steps. Vaping above it risks a dry hit and uses up the head faster.

Matching devices

The head is listed for the pods of the Aegis Boost Pro 1 and Aegis Boost Pro 2, the Aegis Boost Plus and Pro RBA pod as well as for the Obelisk 60 and Z100C DNA sets. You can find heads for other devices among the atomizer heads.

How to change the coil

1. Switch the device off and take the pod or tank off the battery device.
2. Empty the pod or tank and take out the old head.
3. Insert the new head straight and firmly.
4. Fill and wait a few minutes so the cotton is soaked through.
5. Start with low power in the wattage range of the head and only increase afterwards.

Scope of delivery

• 5 × Geekvape P Series head 0.4 ohm

Frequently asked questions

What draw is the head intended for?

For DL. With 0.4 ohm and 50 to 60 watts, it is not a head for the tight mouth-to-lung draw (MTL).

When do I have to change the coil?

Atomizer heads are wearing parts. If the vapor tastes burnt or the vapor amount drops, the head is due.