Dash - Tradi - Bowl - Classic

The D.A.SH Tradi Classic is a plug-in glass base in a classic, vertically accentuated shape. It is about 26 to 27 cm tall, up to 14.5 cm wide and weighs about 1.45 kg. It is made in Spain and intended for medium-sized hookahs.

Slim neck, reduced volume

The Tradi Classic has a slim neck and a reduced volume; the shape is vertically accentuated. Symmetrical cuts refract the light. The look suits classic hookah setups.

Regular glass instead of crystal glass

The glass is transparent. The Glass base is made of regular glass and is lighter than a crystal base. Depending on the batch it is mouth-blown or pressed. On pressed bases fine mould seams may be visible, and small air inclusions are possible. This is part of the production. The neck opening measures 4.5 cm inside and 7 cm outside.

Plug-in base without thread

The Tradi Classic has no screw thread. The stem is pushed into the neck of the base with a silicone seal, so the base only fits hookahs with a plug-in system. Before buying, measure your downstem including diffuser; it must not touch the glass bottom inside the base.

How to use the Tradi Classic

1. Hold the downstem with diffuser into the base and check that it does not touch the bottom.
2. Fill in water until the downstem is submerged about 2 to 3 cm.
3. Push the stem with the seal firmly into the neck of the base.
4. Stand the hookah upright, attach the hose and start smoking.

Care

Rinse the base by hand with lukewarm water after the session, with mild washing-up liquid if needed. Not in the dishwasher. Avoid boiling water and rapid temperature changes; glass does not tolerate thermal shock.

What's in the box

• 1 × D.A.SH Tradi Classic Bowl

Frequently asked questions

What is the difference between the Tradi Classic and the Tradi Gyal?

The Tradi Classic is the plain, vertically accentuated shape with symmetrical cuts. The Tradi Gyal has golden appliqués and a more bulbous lower part. Both are separate models.

Is the Tradi Classic a plug-in base?

Yes. It has no screw thread and is pushed onto the stem with a silicone seal.

Are seams in the glass a defect?

No. On pressed bases fine mould seams are normal, as are small air inclusions.