DotMod - dotPod Plus Pod - Tank - 0.8 ohm - 2 pcs.

DotMod dotPod Plus Pods are refillable replacement pods with built-in mesh coils for the DotMod dotPod Plus Kit. According to retailers, the tank holds 3 ml. Available in 0.6, 0.8 and 1.0 ohm, with two pods per pack.

Technical specifications

• Tank capacity: 3 ml
• Material: PCTG, transparent
• Colour: Black, black-tinted tank with a black base
• Filling: from the side (side-fill) with a silicone plug; the pod stays in the device
• Coil: built-in, mesh
• Leak protection: five layers, according to the retailer

Resistances and power

The 1.0 ohm pod is designed for 14 to 16 watts. The lower the resistance, the higher the wattage range. The dotPod Plus Kit adjusts up to 35 watts. In AUTO mode, it detects the resistance of the installed pod and sets a suitable power level.

Compatible devices

The pods are for the DotMod dotPod Plus Kit . As the coil is built in, replace the entire pod when it wears out.

How to use the pod

1. Open the silicone plug on the side of the pod and fill with e-liquid. The pod does not need to be removed from the device for this.
2. Close the plug again.
3. Leave the pod for a few minutes to let the cotton in the coil soak.
4. Start at low power within the wattage range for the resistance.

What's included

• 2 × DotMod dotPod Plus Pod with coil in the selected resistance
• Liquid is not included

Frequently asked questions

Do I have to remove the pod to fill it?

No. Fill through the side opening directly in the device.

Can I replace the coil?

No, the coil is built into the pod.

Which resistance should I choose?

The pods are available with 0.6, 0.8 and 1.0 ohm. The higher the resistance, the lower the wattage range: the 1.0 ohm pod is designed for 14 to 16 watts. Retailers describe the range as suitable for MTL and a more open draw.