OXVA - Xlim Pro 2 DNA Pod - Kit - Silk White

The OXVA Xlim Pro 2 DNA Pod is a stick-format pod kit with an Evolv DNA chipset. It has a built-in 1300 mAh battery, adjusts from 5 to 30 W and uses Xlim Top-Fill SS Pods with 2 ml capacity and a stainless steel mesh coil. The device measures 114.5 × 25 × 15 mm, weighs 67 g and has a 0.56-inch colour display.

Battery and chip

Charging is via USB-C at 5 V / 2 A. The DNA chip includes two functions. Anti-Burn monitors coil temperature and reduces power or interrupts the draw when too little e-liquid is supplied, to prevent scorching. With Replay, use the heart button to save a draw and recall it at any time. Via USB and the Escribe PC software, you can adjust power curves, boost, display, LED and safety settings. Depending on the colour, the body is made of zinc alloy or carbon with IML.

Pod and coils

The Xlim Top-Fill SS Pods hold 2 ml and fill through a silicone plug at the mouthpiece without removal. The mesh coil is built into the pod, which is held magnetically. SS Pods are available with 0.4, 0.6, 0.8 and 1.2 ohm. Anti-Burn and Replay work only with SS Pods. Standard Xlim Top-Fill, Xlim EZ and Xlim V2 pods fit the device, but without these two functions.

Operation

The device starts by draw activation or the fire button, which also controls settings. The display shows the puff count among other readings; below it is an LED that you can customise or switch off. Use the airflow slider on the side to adjust airflow between MTL and RDL. The device cuts off after 8 seconds of continuous drawing.

Getting started with the Xlim Pro 2 DNA

1. Charge the device via USB-C.
2. Fill the SS Pod through the silicone plug and leave it for a few minutes to let the coil soak.
3. Start at low power within the wattage range specified in the instructions for your pod, and only increase it after a few draws.
4. Set the airflow slider to MTL or RDL.

You can find replacement Xlim Top-Fill SS Pods under Pods with coils.

What's included

• 1 × Xlim Pro 2 DNA Pod-Mod (mod)
• 1 × Xlim Top-Fill SS Pod with 0.6 ohm (pre-installed)
• 1 × Xlim Top-Fill SS Pod with 0.8 ohm
• 1 × lanyard
• 1 × USB-C charging cable
• 1 × quick start guide
• 1 × instruction manual

Frequently asked questions

What is the difference compared with the Xlim Pro 2?

The DNA Pod has an Evolv DNA chip with Anti-Burn and Replay and uses SS Pods with stainless steel mesh coils.

Do Anti-Burn and Replay work with every Xlim Pod?

No, only with Xlim Top-Fill SS Pods. Other Xlim Pods fit, but without these functions.

Do I need the Escribe software?

Escribe is used for advanced settings and requires a USB connection to a PC. The device itself can be operated without it.